Covid 19 announcement
We hope you and your family have been safe over the lockdown period, this is a message to let you know CheckHome is currently taking bookings to start inspecting under level 3, our number one priority is the health & safety of our team and community.
Our team will be taking these measures:- When an inspection is scheduled our team will check that no one has been sick in the property or is self-isolating.
- When CheckHome sets up an appointment for the inspection we will inform the client-vendor and/or agent and any other occupants – of our team's requirements to safely undertake the inspection. This will likely include the need for the house to be vacated by everyone before the interior inspection takes place and the 2-meter physical distancing requirements.
- When we arrive at the property we will make a note of all people onsite on the day of the inspection. This information will help with the “tracking and tracing” process should it be found that someone on-site had been exposed to the COVID-19 virus.
We will maintain the required physical distancing put in place to stop the spread of the virus – i.e. stay at least 2 meters from any other person.
- Our inspectors will set up all equipment outside of our vehicles, this will be wiped down prior to accessing the property, all disposable PPE equipment will go into a rubbish bag so this can be removed without potentially contaminating your vehicle.
We will sanitize our hands before and after the inspection, our inspectors will be wearing a mask and using gloves.
- Only the inspector is to be present in the dwelling at the time of inspection, the agent or vendor representative will need to be in there car or leave the property.
CheckHome building inspection terms and conditions
These terms and Conditions govern the property inspection services that CheckHome will provide to you. You must confirm in writing that you accept the terms and conditions before CheckHome Will provide the property inspection services.
The Terms and conditions cover:
the scope of CheckHome's inspection;
limitations on the resulting inspection report; and
CheckHome's terms of trade.
The inspection and resulting report are undertaken in accordance with NZS 4306:2005, Residential Property Inspection. A copy of this standard is available at our office for inspection, or you may obtain a copy from Standards New Zealand.
The inspection report is the intellectual property of, and upon creation the copyright vests in,
Inspection report personal to you
The inspection report will be prepared exclusively for you. You agree that the inspection report is personal to you and shall not be assigned or disclosed or distributed (other than disclosed or distributed to professional advisors) without the written permission of the CheckHome.
CheckHome accepts no liability to any person other than you. Any third party relying on the contents of the inspection report does so at their own risk and CheckHome disclaims any liability for any loss (direct or consequential), cost or damage resulting.
Limitation of liability
To the extent permitted by legislation, if CheckHome becomes liable to you, for any reason, for any loss, damage, harm or injury in any way connected with the completion of the inspection and/or the resulting report, its liability shall be limited to a sum not exceeding five times the fee paid, or payable, to CheckHome.
CheckHome will not be liable to you for any consequential loss of whatever nature suffered by you or any other person injured, and you agree to indemnify CheckHome in respect of any claims concerning any such loss.
You are responsible for paying CheckHome’s fee. An invoice is sent with the inspection report. Total payment is required within 7 days of receipt of the invoice. An additional service charge of $100 will be added to any debt collection fees.
You must pay CheckHome default interest compounding monthly on all monies due but unpaid, for the period from the expiry of the time provided for payment until actual payment. The right to default interest is additional to any other remedy that CheckHome may be entitled to. The rate of default interest is 7% per month.
CheckHome is entitled to recover from you, on an indemnity basis, all costs and expenses, including legal costs on a solicitor/client basis, incurred in connection with the recovery of any amount due and payable by you to CheckHome.
We accept Visa, MasterCard, American Express, and JCB payments from customers worldwide. There will be a 3% transaction fee charged if paying by credit card. No fee will be charged if paying via internet banking. Our bank details are located on your invoice.
A cancellation fee may be charged by CheckHome if an inspection is cancelled within 24 hours of the time arranged. The amount of the cancellation fee is recorded on CheckHome’s website on the services page.
We realise unexpected circumstances may require booking adjustments or cancellations but please note that any changes must be made 24hrs prior to the inspection to avoid any fees. If you cancel your appointment less than 24 hours before your inspection is scheduled to take place, you will be subject to a cancellation fee of $195. To avoid a cancellation fee, please provide cancellation notice at least 24 hours prior to your inspection. You can cancel or reschedule an appointment by calling or emailing us.
Site Re-check Fee
Your engagement of CheckHome allows for one site visit per inspection. If, for any reason, you request an additional site visit, it will incur a site re-check fee. The amount of the site re-check fee is $195 for the first hour on site and $125 per hour after that.
Consumer Guarantees Act
Nothing in these terms and conditions limits your rights under the Consumer Guarantees Act 1993.
Scope of the inspection - visual inspection only
The scope of CheckHome's inspection is limited to a visual inspection of the components of the building that the inspector has reasonable access to and that are in the inspector's clear line of sight.
The inspection will not include:
examination of any areas or components which are concealed or closed behind finished surfaces (such as plumbing, drainage, heating, framing, ventilation, insulation or wiring) or which require the moving of anything which impedes access or limits visibility (such as floor coverings, furniture, appliances, personal property, vehicles, vegetation, debris or soil);
intrusive or destructive inspection of any part of the building or any building component, disassembly of equipment, or the removal or testing of electrical or other building components or materials.
In a multi-unit property, the inspection and resulting report will only cover the condition of the interior and accessible parts of the immediate exterior of the unit and any related accessory units.
Reasonable access to be provided
You agree to ensure that reasonable access can be gained to the property, including but not limited to the roof cavity and foundation spaces and any such spaces if they exist are cleared for an inspection to be carried out.
'Reasonable access' means access that is safe, unobstructed and which has a minimum clearance of 600mm for a roof cavity and 500mm for a floor cavity.
For safety reasons, access to the exterior of any roof surface for inspection purposes will only occur if:
the Weather is fine;
the Roof is dry;
the roof slope does not exceed 35°; and
the roof height does not exceed 2m.
Any area of the property that cannot be reasonably accessed will not be inspected and will be excluded from any inspection report. The report will state the areas that could not be inspected.
Scope of the inspection report
The inspection report should be seen as a reasonable attempt to identify any significant fault or defect visible at the time of the inspection, rather than an all encompassing report dealing with the building from every aspect. The reporting of any significant fault or defect is on an exceptional basis, rather than reporting on items, which are in an acceptable condition for their age.
We define significant fault or defect as 'a matter that requires substantial repairs or urgent attention and rectification'.
We will address the significant fault and/or defect in the summary section of the inspection report as maintenance or remedial work.
Limitations of the inspection report
The inspection report is intended only as a general guide to help you make your own evaluation of the overall condition of the building and is not intended to reflect the value of the premises, nor make any representation as to the advisability of purchase.
The inspection report expresses the opinions of the inspector, based on his or her visual examination of the conditions that existed at the time of the inspection only.
The inspection and resulting report are not intended to be technically exhaustive, or to imply that every component was inspected, or that every possible defect was discovered.
All building components and conditions which, by the nature of their location are concealed, deliberately hidden, camouflaged or difficult to inspect are excluded from the report.
Any suggestions or recommendations contained in the inspection report are suggestions only and it is the responsibility of the person or persons carrying out any design or building work to ensure that the most appropriate remedy is carried out in conjunction with any further discoveries, warranties or manufacturer's recommendation and warranties, and any necessary local authority concerns conveyed prior to proceeding with remedial work.
Inspection of the systems at the building are outside the scope of our inspection report. The inspector will, however, conduct a cursory check of the hot water system, the plumbing system, and the electrical system. You should note this will only be the opinion of the inspector, who is not a qualified plumber, electrician or gas fitter.
The inspection and resulting report should not be construed as a compliance inspection of any building, legal or territorial authority standards, codes or regulations. The inspection report is not intended to be a warranty or guarantee of the present or future weather tightness, adequacy or performance of the structure, its systems, or their component parts. The inspection report does not constitute any express or implied warranty of merchantability, fitness for use or habitation, or building code compliance and it should not be relied upon as such. Any opinions expressed regarding adequacy, capacity, or extended life of components are general statements based on information about similar components and occasional variations are to be expected between such estimates and actual experience.
You accept that the inspector will not detect some faults because:
The fault only occurs intermittently.
Part of the building has not been used for a while and the fault usually occurs after regular use (or detection of the fault would only occur after regular use).
The type of weather that would normally reveal the fault is not prevailing at, or around, the time of the inspection.
The fault has been deliberately concealed.
Furnishings are obscuring the fault.
We have been given incorrect information by you, the vendor, the real estate consultant, or any other person.
The fault is/was not apparent on a visual inspection.
Should any dispute arise as a result of the inspection or resulting report, it must be submitted to CheckHome in writing immediately.
You agree that upon raising a dispute, the contents of the inspection report may not be used to satisfy any terms of a sale and purchase agreement until the disagreement/dispute has been resolved.
You agree that if, after raising a dispute, you used the inspection or resulting report to make an unconditional offer or confirm the sale and purchase agreement, that you waive all of your rights to continue with the dispute, and/or raise any future dispute or claim about the inspection or resulting report with CheckHome.
In the event of a claim/dispute regarding damage to a building, you will allow CheckHome to investigate the claim prior to any repairs to the building being undertaken or completed. You agree that if you do not allow CheckHome to investigate the claims of damage before any repairs are carried out, that you waive your rights to continue with and/or make any claims against CheckHome.
In the event of any dispute, you agree not to disturb, alter, repair, or attempt to repair anything that may constitute evidence relating to the dispute without first providing CheckHome with a reasonable opportunity to reinspect the building, except in the case of an emergency. You agree that if you do not provide CheckHome with a reasonable opportunity to reinspect the building before anything that may constitute evidence relating to the dispute is disturbed, altered, or repaired, that you waive your rights to continue with and/or make any claims against CheckHome.
Inspections will be completed by our building inspector Craig on houses within all Taranaki districts including New Plymouth, South Taranaki and Stratford.Book now
Craig has recently moved back to Taranaki and has a large background in building and inspecting both throughout New Zealand and Australia. His expertise provides sound advice for all owners and buyers in the market.ENQUire NOw
See our Covid-19 (coronavirus) updates here >
CheckHome provides comprehensive building reports in Wellington, Kapiti, Wairarapa, Manawatu/Horowhenua, Canterbury and Taranaki. Whether you’re buying, selling or building, our team of qualified building inspectors will provide you with a professional report that covers important areas of concern around the property.
Our clients love our quick turn-around, our Pre Purchase building reports are generally generated within 24 hours of a building inspection.
A pre-purchase inspection is carried out before you make an offer on a property or once your offer is accepted.
A pre sale property inspection provides a full, in-depth report on the condition of the property.